Rotex EKRTETS, Installation Manual

Page: 42 / 248

Installation manual
11
RKRTR + EKRTETS
Room thermostat
4PW56107-1
6 Put the cable bracket back into place and tighten the screws.
7 Close the receiver cover and tighten the screws.
Receiver-thermostat radio configuration
You need to configure the radio connection between the receiver
and the thermostat in order to make communication possible.
1 Put the receiver in radio configuration mode by pressing
k
during 4 seconds.
The
LED lights up green and the receiver is now waiting for
a thermostat configuration address.
If needed, you can simply exit this mode by pressing
k
again.
2 Send the configuration address by going to code
‚
(
‚žºŸp¶
)
in the installer menu on the thermostat.
Refer to “Setting up codes in the installer menu” on page 14.
The thermostat will now send radio signals. On the LCD the
icon
L
flashes.
3 Verify that the radio signals are correctly received by the
receiver.
If the configuration is OK, the
LED blinks green at each
radio signal received from the thermostat.
This also means that the receiver has left the radio
configuration mode.
4 On the thermostat, exit the installer menu by pressing till
the " " code is displayed and then pressing .
5 Verify if the receiver is in thermostat mode and not in manual
mode by checking if the
k
LED is off.
Refer to "LED overview" on page 12.
Make sure to protect the power supply with a fuse of
3 A (X2M).
Select the power cable in accordance with relevant
local and national regulations.
A main switch or other means for disconnection,
having a contact separation in all poles, must be
incorporated in the fixed wiring in accordance with
relevant local and national legislation.