28
User manual
ANZU remote control
EN
REMOTE CONTROL SUPPORT
7.6. FP function
The unit will operate at high fan speed (while compressor on) with temperature
automatically set to 8°C/46°F.
2
NOTE:
This function is for heat pump air conditioner only.
To activate the FP function, start the air conditioner in heating mode, set the lowest available temperature
(17°C/63°F), then press the down arrow button 2 times within one second.
If you press any buttons: ON/OFF, Sleep, Mode Fan or up/down button while the FP function is working it will
be canceled.
7.7. LOCK function
Clean
5s
Turbo
+
5s
Press together Clean button and Turbo button at the
same time more than 5 seconds to activate Lock function.
All buttons will not response except pressing these two
buttons for two seconds again to disable locking.
7.8. SET function
or
SET
SET
OK
• Press the SET button to enter the function setting, then press SET button or TEMP or TEMP button
to select the desired function. The selected symbol will flash on the display area, press the OK button to
confirm.
• To cancel the selected function, just perform the same procedures as above.
• Press the SET button to scroll through operation functions as follows:
Follow Me ( ) AP mode ( ) Follow Me ( ) ...
Follow me function (
):
The FOLLOW ME function enables the remote control to measure the temperature at its current location and
send this signal to the air conditioner every 3 minutes interval. When using AUTO, COOL or HEAT modes,
measuring ambient temperature from the remote control(instead of from the indoor unit itself) will enable
the air conditioner to optimize the temperature around you and ensure maximum comfort.
Summary of Contents for ANZU
Page 30: ...NOTES...
Page 31: ...NOTES...
Page 32: ...email info rotenso com www rotenso com PIECZ INSTALATORA...
