BRP-Rotax
INSTALLATION INSTRUCTION
INSTALLATION OF THE WIRING
HARNESS
The wiring harness is delivered partly pre-assembled
to facilitate the installation. This means that the relay,
the multiple function switch and the battery cover are
already pre-assembled and wired.
NOTE
The connector assignment is shown on the fol-
lowing pages. Details on the assignment of ca-
bles and pins are given in the wiring diagram.
NOTE
Cable lugs may break after repeated bending.
Step
Procedure
1
Place the wiring harness loosely on
the chassis.
NOTE
Always start the installation at the engine side to
work without tension on the wiring harness.
ATTENTION
Strain relief of the plug connections must be
ensured.
NOTE
Compensate excessive length of wiring harness
by routing cables in loops.
m
WARNING
Non-compliance can result in serious injuries
or death!
The wiring harness must not touch moving
parts of the track.
NOTE
When unplugging connections on ignition pick
up and ignition coil, press the integrated catch
first.
NOTE
Disconnect any electrical plug connection only
by pulling against the plugs.
Step
Procedure
2
Pre-mount the large cable tie (pos.1)
through the two holes provided on the
mounting plate (pos. 2).
Figure 4.1
Step
Procedure
3
Connect solenoid valve (pos. 1) and
ignition coil (pos. 2). Attach both con-
nectors (signed green) (pos. 3) to the
two components.
Page 2
Edition: March 01 2021
Effectivity: 125 MAX evo, Junior MAX
evo, Mini MAX evo, Micro MAX evo
Summary of Contents for 125 JUNIOR MAX evo
Page 54: ......
