Rotary GLP99SM, Operating Instructions Manual

Page: 6 / 27

6

WARNING:
“GLP99SM-GLP99SMP” car lift has been designed and built to lift and place cars in closed areas. Any other use is
forbidden, and particularly, the following operations cannot be performed:
-VARNISHING - LIFTING OF PEOPLE OR SCAFFOLDING - SQUASHING PRESS - CAR JACK OR WHEEL REPLACEMENT.
CHARACTERISTICS
•
Low-voltage controls (24V).
•
Power unit with electromechanic card.
•
Hydraulic-volumetric synchronism of platform.
•
Acoustic signal at the end of the lowering cycle.
•
Mechanical safety system.
•
Hand lowering device in case of power failure.
•
Double auto-levelling platform device.
•
Magnetic induction limit switches.
•
“Touchpad” control.
•
Safety valve in case of hydraulic failure.
TECHNICAL DATA
•
Operation Electro-hydraulic.
•
Capacity 3000 kg.
•
Weight From 900 to 1000 kg.
•
Lifting time 50 sec.
•
Lowering time 50 sec.
•
Max. lifting height 1850 mm.
•
Motor 3ph 3kw 220/380V 50Hz.
•
Noise level <76 dB.
•
Working temperature -10°/+50°.
Working max pressure 250 Bars
The direction of the motor is clockwise, as shown in the table placed on the motor.
CHAPTER 3
– SAFETY
Read this chapter carefully it contains important information concerning the safety of the operator. The operator and the
maintenance personnel are required to observe the accident prevention legislation in force in the country of installation of the
lift.

1 During lifting or lowering operations, the lift must be operated only from the operator area as shown in the diagram.

2 Stopping or passing within the danger area when the lift is working or already raised is strictly forbidden. Only the
operator is allowed to stay under the lift.

3 The operator must make sure the hazard area is clear when lifting or lowering the lift

4 Never use the lift without protection or when safety devices are off-line.
 5 Always use the rubber pads when lifting a vehicle, observing the proper points of support specified by the vehicle’s
manufacturer.

6 Switch off the engine and engage the parking brake after placing the vehicle on the car lift; Furthermore, disengage the
shift lever and move it to the “neutral position.

7 To prevent the vehicle from falling make sure it is properly placed on the lift.

8 Getting in or on the vehicle and-or starting the engine when the car lift is raised is strictly forbidden.

9 Never leave objects and-or obstructions under the vehicle or scattered on it during the lowering phase.

10 Keep the area under/next to the lift clear and remove possible oil spots to avoid the risk of slipping.

11 Never use water-steam-varnish-solvent jets in the lift area, and particularly, close to the control box.

12 Proper lighting is extremely important. Make sure all areas next to the car lift are well and uniformly lie, according to
that specified by the applicable laws of the place of installation.

13 Climbing on the platform when lifting the vehicle or when the same has been already raised is strictly forbidden.

14 Any use of the lift other than what herein specified can cause serious accidents to the operator as well as to the
people in close proximity.

15 The tampering of safety devices is strictly forbidden.

16 Never exceed the maximum lifting capacity. Make sure the vehicles to be raised are without loads.

17 In case of anomaly, stop the car lift and block the on/off selector by using a padlock. Only skilled technicians
should be allowed to restart the lift. Be sure the power supply is off before repairing and servicing the lift. The
operator, the lift or the vehicles raised can be seriously damaged if these instruction are not followed.