USER'S AND
MAINTENANCE
MANUAL
Date:
01/31/2020
Code
MAN D185T4F-DB
ENG
Air Compressor : D185T4F-DB
Revision 03
Copyright © 2014, ROTAIR S.P.A. - All rights reserved
.
This manual is intellectual property of ROTAIR S.P.A.
Its full or partial reproduction is forbidden under any form, on any support and by any means, without the
written authorization by ROTAIR S.P.A.
Page
34/59
10
RECOMMENDAT
IONS FOR THE
PROPER OPERATION
OF THE
AIR
COMPRESSOR
Consult this user's and maintenance manual before starting
the machinery.
10.1 Before startin
g
S
trictly follow the instructions
outlined in the manual
:
1)
Level the machine by adjusting the support foot or the wheel; no incline greater than 15° is allowed
.
2)
Check that the battery cables are connected to the battery correctly; if the cables need to be connected,
use
care and verify that the cable coming from the starter motor is connected to the positive pole (+) of the
battery
and that the ground cable is connected to the negative pole (-) of the battery.
3)
Check the fuel level in the tank. USE DIESEL FUEL ONLY.
4)
Check the level of the engine oil. As related to the types of lubricant and correct quantities, comply with the
recommendations contained in the engine manufacturer's user's and maintenance manual included with
the
machinery documentation.
5)
Check the oil level in the compressor. Stop the machine and allow it to sit for at least 5 minutes, allowing
the
lubricant to return to the oil mist separator tank.
Before unscrewing the dipstick, level the machine, making
sure that there is no pressure in the system
(
t
he pressure gauge shall indicate 0 bar/psi)
.
a)
Remove and clean the dipstick.
b)
Thoroughly screw the dipstick back in and then remove it again to verify that the lubricant level is between
the two engraved marks (min. and max. level).
c)
Top off the oil if required; the level must never exceed the max. mark.
d)
Exclusively utilize the types of oil recommended in this user's and maintenance manual.
Figure 10.1-1 Checking the oil level in the compressor