1. Handlebar installation:
⚠
Failure to properly adjust and tighten the bolts can cause loss of control and crash.
Place handlebars into position on the bracket on the top of the steering column, cover with
the top handlebar bracket and loosely install 2 of the provided nuts & bolts in the set of
holes closest to the rider. Slide the ignition switch plate between the front of the top and
bottom bracket, aligning the holes. Install the remaining bolts into the front set of holes,
adjust handlebars to desired position and tighten all hardware.
2. Fender installation:
Remove the bolts from the fender brackets located near each wheel. Align fender holes with
the holes on the bracket and reinstall the bolts you just removed, with the nuts on the
inside of the fender.
6
