EN - 4
Installing Batteries
1. Place your thumb on the side of the battery cover. Push the battery cover in the right direction
to open it.
2. Install battery in the lower position first. Battery Type: 2 Alkaline LR03 (AAA) size.
3. Place in the other battery.
4. Replace the cover by placing the end tabs of the battery cover in the slots on the top of the
battery compartment. Click in the other end to secure the battery cover.
5. Be sure that the battery cover is in position after battery replaced and before each measure-
ment.
Replace the batteries if:
1. The weak battery mark appears in the display.
2. Nothing appears in the display when the ON/OFF/START key is pressed.
As the supplied batteries are for test only, they may be discharged earlier than batteries you buy in
stores.
Replace the batteries in pairs.
Remove batteries when unit is not in use for extended periods of time.
Caution:
1. Batteries are hazardous waste. Do not dispose them together with the household
garbage.
2. There are no user serviceable parts inside. Batteries or damage from old batteries
are not covered by warranty.
3. Use exclusively brand batteries. Always replace with new batteries together. Use
batteries of the same brand and same type.
Applying the Cuff
1. Remove all watches, jewelry, etc. prior to attaching the wrist monitor.
Clothing sleeves should be rolled up and the cuff should be wrapped on bare skin for correct
measurements.
2. Apply cuff to left wrist with palm facing up as Fig. A.
3. Make sure the edge of the cuff is about 1 cm from the palm as Fig. B.
4. In order to ensure accurate measurements, fasten the velcro strap securely around your wrist so
there is no extra space between the cuff and the wrist as Fig. C.
If the cuff is not wrapped tight enough, the measurement values may be false.
5. If your physician has diagnosed you with poor circulation on your left arm, carefully place the
cuff around your right wrist as shown in Fig. D.
Fig. A
Fig. B
Fig. C
Fig. D