T e c h n o l o g y f o r c l e a n p o n d s
Working with the BISAM 22 BRUSH
The BISAM 22 BRUSH is designed to clean surfaces under water. Particularly on even floor surfacesLay
the rotating brush on the pond floor, regulate the forwards-backwards switch and switch on the suction
cleaner. When working on rough ground, the brush will wear out more quickly, so make sure you use a
brush with the suitable grade of hardness for the surface being cleaned. Do not press the rotating brush
too strongly onto the surface as this may cause damage to the motor or gears or could damage the foil.
With the BISAM 22 BRUSH it is possible to attach a suction hose with a diameter of 50 or 38 mm to the
built-in suction connector. If using the suction possibility at the same time, the dirt can be removed and
the clarity of the water is maintained. A clouding of the water is for the most part avoided. Using the
speed control unit, you have the possibility to choose between three different speeds in each direction.
The rotation speed you choose is indicated by an LED light.
For the wall surfaces we recommend a faster, for
the horizontal surfaces a rather slower rotation speed. In order to avoid damaging sensitive surfaces
like foil, we recommend starting with the yellow Vacu-grip brush attachment. As an option, you can,
however use the harder Vacu-grip brushes in red = medium hard or green/red = hard. This is advisable
in the case of hard or encrusted dirt. The loaded power unit can be easily transported using the strap
provided, just clip the power unit into the power unit holder.
The BISAM 22 BRUSH can now be steered by the telescopic rod and the cleaning of the surfaces in the
pool or pond will be systematically carried out.
Changing the brush
Attention! Before carrying out any maintenance work on the BISAM 22 BRUSH, please disconnect the
brush from the power supply.
Pay particular attention, before making any changes, that you turn the battery switch to the O position.
Press the round brush in the direction of the driving gear and then pull it outwards from the other side.
To assemble follow this procedure in reverse.
12
1
2
