AY-B9350 User Manual
40
3.6.2. Fingerprint Recognition
Select [System
]
à
[Fingerprint recognition]
in the main menu to display the screen
below.
▶
Default setting: same with the setting in the left
screen
▶
1 to N level (3~9)
This authentication level is used for 1 to N fingerprint
verification. Since authentication level for each user is
not set for 1 to N identification, it is always based on
the authentication level of the terminal.
▶
1 to 1 level (1~9)
This authentication level is used for 1 to 1 fingerprint
verification. However, 1 to 1 verification level of the
relevant user will be performed for the user for whom
1 to 1 verification level is not to set ‘0’ (use
authentication level of the terminal).
▶
Fake Finger Detection
This is to set LFD level to prevent input of fake fingerprint. The higher LFD level, the
higher function to prevent input of fake fingerprint made of rubber, paper, film or silicon.
However, sometimes input of real fingerprint can be difficult if fingerprint is too dry.
▶
Check similar FP
If this item is checked (
), check fingerprint whether it is an already registered
fingerprint to prevent reregistering it as another user ID by duplicating a same
fingerprint. The function is only for the users who are saved at the terminal. It is a
separate function from similar fingerprint prevention function of the server.
To apply the setting value, press [OK] button or press [BACK] button to cancel and to
move to the upper menu. If [OK] button is pressed without changing the setting value,
directly move to upper menu.