Rosslare AC-115, Software Manual

Page: 45 / 94

Set Up Your First Door
AC-115 Software Installation and User’s Guide Page 44
Figure 50: Configure Duress Code
3. Click Add to add a new Duress Code.
4. Click Defaults to reset the Duress Code to its factory default
value.
5. In the window you will find the Code type, PIN or Prox, and
the value of the PIN Code or the Card ID Code.
6. Click Add and continue on the next page.
You will see the Code type selection window shown below.
There are three methods to enter the code:
Figure 51: Select Code Type
• Prox Card:
o
The Door checkbox adds a code using a reader
that is attached to any AC-115 hardware in the
network.
o
The MD-08 checkbox adds a code using any 26-
Bit Wiegand compatible reader attached to the
PC using the MD-08, a 26-Bit Wiegand to RS232
Converter Accessory. (Purchased separately).
(See Appendix B for more information on the
MD-08.)