Ross SEA-8203A, User Manual

Page: 15 / 36

SEA-8203A User Manual (Iss. 01) Installation and Setup
•
2-3
5. Align the top hole of the rear module with the screw hole on the top edge of the
frame back plane.
6. Using a Phillips driver and the supplied screw, fasten the rear module to the frame
back plane. Do not over tighten.
7. Ensure proper frame cooling and ventilation by having all rear frame slots covered
with rear I/O modules or blank metal plates. If you need blanks, refer to the chapter,
“
Ordering Information ” in your DFR-8300 series frame User Manual, and contact
your Ross Video sales representative.
This completes the procedure for installing the rear module in a DFR-8300 series frame.
Board Installation
Use the following procedure to install the SEA-8203A in a DFR-8300 series frame:
1. Refer to the User Manual of your DFR-8300 series frame, to ensure that the frame is
properly installed according to instructions.
2. After selecting the desired frame installation slot, hold the SEA-8203A card by the
edges and carefully align the card edges with the slots in the frame.
3. Fully insert the card into the frame until the rear connection plugs are properly
seated on the midplane and rear modules.
This completes the procedure for installing the SEA-8203A in a DFR-8300 series frame.
BNC Labels
Affix the supplied BNC label, as per the included instructions, to the BNC area on the rear of the rack
frame.
Cable Connections
This section provides instructions for connecting cables to the installed BNC rear modules on the
DFR-8300 series frame backplane. Connect the input and output cables according to
Figure 3 . The
inputs are internally terminated in 75 ohms. It is not necessary to terminate unused outputs.
Figure 3. Cable Connections for the DFR-8310 frames with R1-8203 Rear Modules