Ross SEA-8203A, User Manual

Page: 14 / 36

2-2
•
Installation and Setup SEA-8203A User Manual (Iss. 01)
Rear Module Installation (Optional)
The SEA-8203A is compatible with the DFR-8310 and DFR-8320 series frames. The procedure for
installing the Rear Module in your openGear frame is the same regardless of the frame or module
used. However, a different module is required depending on the openGear frame you are using.
Rear Modules for the SEA-8203A
The Rear Module for the SEA-8203A depends on the openGear frame you are installing the card into.
•
DFR-8310 frames — When installing the SEA-8203A in the DFR-8310 frames, a R1-8203
Rear Module is required. The SEA-8203A is also compatible with the 100-BNC Rear Module
on the DFR-8310-BNC frame.
•
DFR-8320 frames — When installing the SEA-8203A in a DFR-8320 series frame, a Split
Rear Module ( R2S-8203 ) or a Full Rear Module ( R2-8203 ) can be used.
Installing the Rear Module
If you are installing the SEA-8203A in a DFR-8310-BNC frame, or the Rear Module is already
installed, skip this section.
Use the following procedure to install the rear module in an DFR-8300 series frame:
1. Refer to the openGear DFR-8300 series frame User Manual, to ensure that the frame
is properly installed according to instructions.
2. On the rear of the frame, locate the card frame slot.
3. Remove the Blank Plate from the rear of the slot you have chosen for the SEA-
8203A installation. If there is no Blank Plate installed, proceed to the next step.
4. As shown in Figure 2 , seat the bottom of the rear module in the seating slot at the
base of the frame’s back plane.
Figure 2. Rear Module Installation (SEA-8203A not shown)