Ross RPPW2600, Manual

Page: 16 / 20

X
MAINTENANCE
7!4%2).,%4&),4%2
s This pressure washer is equipped with a
water inlet filter.
s This water filter must be kept clean at all
times or else it will restrict the water flow to
the pressure washer and may damage the
pump.
s Remove the quick connect coupling from the
water inlet, then remove and clean water filter.
s DO NOT operate this pressure washer
without the water inlet filter in place as
deposits could build up internally and affect
the functioning of the unit.
See in-store for replacement filters.
ENGINE MAINTENACE:
Engine Oil Replacement
s Engine oil should be replaced after the first 20 hours of operation or after the first month of use.
s It should be replaced every 100 hours or 6 months.
s To replace engine oil; Loosen the oil gauge dipstick(A). Place an oil
pan underneath drain hex bolt(B), remove hex bolt and drain oil.
Once all the oil has completely drained, retighten the hex bolt.
Recommended Engine Oil
s It is recommended to use SAE10W-30 4-stroke gasoline engine oil.
s Fill with clean engine oil through the oil gauge dipstick hole to recommended level.
Inspecting, Replacing or Cleaning Spark Plug
s The spark plug should be checked every 100 hours of operation or every 6 months.
To replace or clean spark plug:
1) Dismantle the spark plug wire(A) by pulling it off the spark plug(B).
Using the supplied spark plug wrench, undo the spark plug by turning
counter clockwise.
2) Check to see if there is carbon sediment build-up, if so, remove it.
If the carbon sediment is excessive, replace the spark plug.
3) Measure the electrodes clearance using a feeler gauge. The spark plug electrode clearance should
be between 0.7-0.8 mm. If the clearance exceeds 0.8 mm, replace the spark plug. The original spark
plug supplied is an LG F7RTC, you can replace it with an NGK BP6ES spark plug or equivalent.
16 | P a g e