Ross RPPW2600, Manual

Page: 11 / 20

X
PRE-START CHECK OIL LEVEL
WARNING! Pressure washer has no oil currently in crankcase! Operating the unit without the
correct amount of oil will damage the engine. Oil crankcase capacity: 0.6 L.
Always check the oil level before starting the engine, make sure the pressure washer is on a
level surface before checking oil level. Always use SAE 10W-30 oil.
4O#HECK/IL,EVEL
1) Turn the oil gauge dipstick (A)
counter clockwise; remove it and clean it with a
clean cloth.
2) Fully reinsert the oil gauge dipstick and pull it
out to check the oil level.
3) If the oil level is halfway up the dipstick or
below, refill with SAE 10W-30 oil through the
dipstick hole until the oil level reaches 3/4 up
the dipstick or until it reaches the bottom lip of
the dipstick hole as shown in illustration to the
right.
4) Re-position the oil gauge dipstick and tighten it
by turning clockwise.
PRE-START CHECK FUEL LEVEL
WARNING! Make sure there is enough fuel in the fuel tank before operating.
Check the fuel level indicator window(A), if the red float gauge is all the way up, it is not
necessary to add fuel. If the red float gauge is not, or barely visible, it is necessary to add fuel.
1) If it is necessary to add fuel, first make sure
the engine is OFF, and then remove the fuel
cap(B) by turning it counter clockwise.
2) When refuelling, make sure the fuel filter (C)
is in place and keep in mind all safety
precautions.
3) Use clean unleaded petrol with a minimum of
87 octane.
$/./4
use old fuel.
$/ ./4
mix
oil with gasoline. Fuel tank capacity: 4.0 Litres.
*** This is a 4-cycle engine and does not require a
gas/oil mixture. There is a separate reservoir
for gas and a separate reservoir for oil.
11 | P a g e
A
C
B
!