Ross PS-8102, User Manual, Page: 24 / 32

3–4 • Optional Field Upgrade Kits DFR-8110A(-C) User Manual (Iss. 03)
Support Bars and Brackets
This section provides information on installing the FSB-7110 and CSB-8100 options.
Installing the FSB-7110 Rear Support Bars and Brackets
Under normal conditions, mounting the frame to the front of the rack with the four rack screws
provided, should be sufficient to carry the load, including the weight of accompanying cables.
However, Ross Video has specifically engineered the optional FSB-7110 Rear Support Bars and
Brackets to compensate for extra load stress associated with certain applications, such as mobile
truck installations, to also support the rear of the frame
The rear support bars can be attached to the DFR-8110A(-C) in six possible positions. ( Figure
3.3 )
Figure 3.3 FSB-7110 Rear Support Bars and Brackets
Use the following procedure to install the FSB-7110 for the DFR-8110A(-C):
1. Choose the position that suits the cabinet depth and will give approximately ½ inch
projection beyond the rear vertical mounting rails.
2. Using four screws per bar, as shown in Figure 3.3 , fasten one bar to each side of the
DFR-8110A(-C).
3. Mount the DFR-8110A(-C) to the front rails of the rack cabinet using four rack screws
fastened through the front mounting flanges.
4. At the rear of the cabinet:
• Slide the bracket slots over the rear of the support bars
• Secure to the cabinet rear rails with two rack screws each.
This completes the procedure for installing the FSB-7110 for the DFR-8110A(-C).
Installing the CSB-8110A Cable Support Bracket
This bracket, which is specially designed to support the weight of cables connected to the
RossGEAR 8000 series digital frames, prevents strain on the BNC connectors. It attaches to the
frame sides by screws, and extends beyond the frame rear where cables are tied to it.
Note
— You cannot install the FSB-7110 and CSB-8100 in the same frame.