Ross 9516DR-004-03, User Manual, Page: 18 / 26

18 • Cabling DAC-9516 User Guide (v3.0)
To wire the cables for the analog audio signals
1. Gently pull the block from the connector on the DAC-9516 chassis.
Figure 5.2 DAC-9516 — ANLG Audio Connections
2. Verify the silk-screen on the DAC-9516 chassis and Figure 5.2 to locate the pins for each input (A, B).
3. Insert an analog audio wire into the designated polarity slot on the block.
4. Use a tweaker screwdriver to tighten the slot’s connector clamp on the block.
5. Repeat steps 3 and 4 for each wire on each input.
6. Insert the block back onto the unit so that the slotted tongues fit in the grooved side on the block socket.
Power Adapter and Supply
Connect the PS-9000 power adapter to the power supply connector. The PS-9000 provides reg5V DC (5%)
@ up to 2A. The DC power cord has a locking connector that securely fastens into the power supply DC jack on the
DAC-9516. The DAC-9516 has a standard miniature power jack (center pin positive).
To connect the DAC-9516 to the PS-9000
1. Connect the female end of the PS-9000 cable into the socket marked POWER on the DAC-9516 chassis.
Figure 5.3 DAC-9516 — Power Connection
2. Connect the PS-9000 to Mains Power.
Caution
— Use of improper adapters may damage the SMC-9901 and will void the warranty.
OUT A1
OUT A2
OUT B1 OUT B2
Note:
It is recommended that you always connect the PS-9000
to the DAC-9516 before connecting to Mains Power.
PS-9000
POWER
INPUT
B GAIN
A GAIN
AES INPUT
12345678
DIP SWIT
CHES
-+
B2 OUT
-+
B1 OUT
-+
A2 OUT
-+
A1 OUT
DIP
SWITCH
1 2 3 4 5 6 7 8
DOWN
POSITION
CH A
+18
N/A N/A
EMP
OFF
EMP
ON
N/A N/A
CH B +18
UP
POSITION
CH A
+24
N/A N/A
EMP
ON/AUT
O
EMP
AUT
O
N/A N/A
CH B +24
FIL
T
ER
EQUALIZER
RECLOCKER
INTERPOLA
T
E &
OVERSAMPLE
24-BIT
DAC
DAC-9516
AES/EBU to
Analog
Audio Converter