Ross 9201DR-104-03, User Manual

Page: 24 / 32

24 • DashBoard Menus DETOUR User Guide (v3.0)
Network Tab
Table 5.6 outlines the fields displayed in the Network tab that is located near the Setup tab in the right pane of the
DashBoard window.
Reclocker Rate Auto* DETOUR automatically detects the incoming data rate
and sets the reclocker to it
MADI Reclocker is set to 125Mbps
SD Reclocker is set to 270Mbps
HD Reclocker is set to 1.485Gbps
3G Reclocker is set to 2.97Gbps
6G Reclocker is set to 5.94Gbps
12G Reclocker is set to 11.88Gbps
Cable Boost Selected Adds pre-emphasis to the output signal
Cleared* Disables this feature
Out # - Enable Selected* The specified OUT HD-BNC outputs a copy of the SDI
IN signal
Cleared Disables this output. The specified OUT HD-BNC is not
used.
Alarm on LOS Selected* The Signal Presence field in the Status tab reports when
an input signal is not detected
Cleared Disables the alarm.The input signal is not monitored.
Alarm on External
Power Loss Selected* The External Power field in the Hardware tab reports
when the voltage falls below 0.8V.
Cleared Disables the alarm.The Power Supply port on the unit is
not monitored.
Alarm on USB Power
Loss Selected The USB Power field in the Hardware tab reports when
power is supplied via the USB port.
Cleared* Disables the alarm.The USB port on the unit is not
monitored.
Factory Settings Restore Resets all DashBoard editable fields (excluding
network) to the factory default values
Table 5.6 Network Tab
Item Parameters Description
Device Name <text> Provides a unique identifier for the unit in the Tree View
of DashBoard
IP Address #.#.#.# Specifies the IP address for the unit
Subnet Mask #.#.#.# Specifies the subnet mask for the unit
Default Gateway #.#.#.# Specifies the gateway for communication outside of the
local area network (LAN)
Table 5.5 Setup Tab
Item Parameters Description