Attach bottom AnoGotcha holder to vertical poles.
Step 5
AnoGotcha
™
Stand
assembl y continued
AnoGotcha is a registered trademark of Rose Displays, Ltd. Neither the manufacturer nor any
sales agent may be held liable for injury, loss or damage resulting from the use of these products.
Part #02INSAnoGotchaStand
35 Congress Street, Salem, MA 01970
Tel# 1- 800 631-9707 Fax# 1-800-560-2890
e-mail:[email protected]
Slide threaded rod through height
slot that matches the length of your
graphic and through bottom channel
of remaining AnoGotcha holder.
Slide threaded rod through matching
hole on opposite vertical pole.
Attach ball knob, but do not
tighten. Leave loose until
graphic is inserted.
Bottom AnoGotcha must be
attached at slot that matches
the length of your graphic.
60”
48”
28”
28”
60”
48”
• Choose the height slot
that matches the length
of your graphic.
• Slide one threaded rod with
ball knob (created in step 1)
through appropriate hole in
one vertical pole (created in
step 2) and through bottom
channel of one AnoGotcha
holder (created in step 3).
• Slide threaded rod through
corresponding slot of second
vertical pole.
Note:
Make sure the hinge on the
bottom T-Gotcha faces up
and in the same direction as
the hinge on the T-Gotcha
at the top of the stand.
• Loosely screw second
ball knob onto end of
threaded rod.
Note:
Ball knob must be kept loose
until graphic is inserted.
T-Gotcha hinge must face up and in the same direction as T-Gotcha on the top.
