TENSPros
29
Chapter 9: PARAMETER CONTROLS
There are 4 therapeutic modes available –TENS, EMS, IF and RUSS. Each
mode’s parameters can be set by pressing [
SET
] button to enter setting
mode, and then adjust the parameters by pressing [▲] or [▼] button.
9.1 Steps to set a new TENS program
9.1.1 Select TENS therapeutic mode and program
Press [
MODE
] button until the LCD display “TENS” and expected program
(B, N, M, SD1, SD2).
9.1.2 Set pulse width
Press [
SET
] button to enter setting mode, the “Width” indicator displays on
LCD, press [▲] or [▼] button to adjust the parameter from 50μs to 300μs.
9.1.3 Set pulse rate
Press [
SET
] button again, The “Rate” indicator displays on LCD, press
[▲] or [▼] button to adjust the parameter from 2Hz to 150Hz. In Burst (B)
program, you can set the burst rate from 0.5Hz to 5Hz.
9.1.4 Set timer
There are two adjustable timers available. The left timer controlling the
treatment time of CH1 and CH2. The right timer controlling the treatment
time of CH3 and CH4. The treatment time is adjustable from 1 to 60
minutes or C (Continuous). Press [
SET
] button to enter this menu, then
press [▲] or [▼] button to adjust the setting. Press [▲] button when the
timer shows 60 minutes, it will be switched to continuous stimulation.
Two timers can be set in the same way.
9.2 Steps to set a new EMS program
9.2.1 Select EMS therapeutic mode and program
Press [
MODE
] button until the LCD display “EMS” and expected program
(C, S, A).
9.2.2 Set ramp time (A or S program)
Press [
SET
] button to enter setting mode, The “Ramp” indicator displays
on LCD when you select Alternate (A) or Synchronous (S) program, press
Summary of Contents for Twin Stim Plus 3rd Edition
Page 1: ...T E N S P r o s Twin Stim Plus 3rd Edition Combo Stimulator INSTRUCTION MANUAL...
Page 2: ......
Page 39: ......
