Safe-T-Scope
®
Backup Camera System
STSK7360
5
FEATURES AND CONTENTS
Image Device
Pixels
TV Lines
InfraRed LED’s
Night Vision Range
Video Output
Dust\Water Rating
Shock Rating
Vibration Rating
Field of View
Operating Temperature °F (°C)
Storage Temperature °F (°C)
Weight
Dimensions W x H x D
Audio
Construction
1/3” CCD
250,000
380
6 High-Output
30 Feet
1.0 Vp-p, 75 Ohm
IP67
100G
15G
145°
-22° to 158° (-30° to +70°)
-40° to 176° (-40° to +80°)
.5 lb.
2.5” x 1.7” x 2.5”
Yes
Cast Aluminum Housing w/ Stainless Steel
Mounting Bracket & Weather Shield
STS107 CAMERA SPECIFICATIONS
INCLUDES STSH307 (60’ HARNESS)
See fig. 3 ( pg.25)
IMPORTANT: FOR TYPICAL REAR-VIEW INSTALLATION, THE REAR CAMERA MUST
BE CONNECTED TO THE MONITOR POWER DISTRIBUTION HARNESS AT THE
CONNECTOR MARKED “REVERSE”
Note: The following instructions are for a typical rear-view application.
STSC107 CAMERA
1. Attach camera bracket close to rear marker lights, centered on vehicle (see Fig. 1).
Attachment point must be sturdy enough to support camera and bracket.
2. We do not recommend mounting the camera near the lower area of the
vehicle (ex: bumper). This reduces the view of the camera and increases
the chance of physical damage to the camera.
3. Attach camera to bracket using screws provided. Adjust angle as indicated
in Fig. 2. (Use rear bumper and back of vehicle as a reference point.)
4. Wind deflector may be installed. This deflector is designed to reduce the
buildup of dust, dirt and moisture on the camera lens. (See Fig.3)
STSM207 MONITOR
1. Attach monitor inside vehicle in a location convenient to the driver
(ex: center of dash, overhead, or flush-mounted in dash).
2. Attach the “duckfoot“ bracket to the dashboard or to the headliner
using self-tapping screws and/or adhesive pad.
3. Fasten monitor to “duckfoot“ and adjust mounting angle to allow optimum driver
viewing comfort. (See Fig. 4.)
CAMERA
1. The camera to cable connection is waterproof. Be sure to position the cable
properly. The male end attaches to the camera. The female end attaches to the
power/video/audio distribution harness, typically located under the dashboard.
(See Fig. 5.)
IMPORTANT: FOR TYPICAL REAR-VIEW INSTALLATION, THE REAR CAMERA MUST
BE CONNECTED TO THE DISTRIBUTION HARNESS AT THE CONNECTOR
MARKED “REVERSE”
2. Do not run the cable over sharp edges or corners. Do not kink or excessively bend
the cable.
Keep the cable away from hot and rotating parts.
3. Fasten all cable runs, and secure all excess cable.
INSTALLATION INSTRUCTIONS
6
