Mor-Vision
™
Mirror/Monitor Backup Camera System, Installation User Manual
Mor-Vision
™
Mirror/Monitor Backup Camera System, Installation User Manual
7
8
SPECIFICATIONS
STSC109B CAMERA
Pickup Device 1/4” CMOS Sensor
TV System NTSC
Pixels 720(H) x 480(V) NTSC
Sensing Area 5.6mm x 5.6mm
Horizontal Resoulution 420 TV Lines
Signal to Noise Ratio Minimum 45dB
Power Supply 12VDC
Max Power Consumption 1.8W at 12VDC
Current MAX. 75MmA
Lens Angle 150
o
(D)
Operation Temperature -5
o
F to +140ºF (-20
o
C to 60
o
C)
Storage Temperature -5
o
F to +167ºF (-20
o
C to 75
o
C)
Weight 0.23lbs (0.1kg)
Dimensions W x H x D (83.5 x 57.8 x 44.2 mm)
( 83.5 x 57.8 x 44.2 mm )
STSM217 MONITOR
Screen 7.0 inch Color TFT-LCD High Brightness
Voltage Input Range 12 to 24 VDC
Power MAX. 75MmA
Max Current Consumption 850 mA at 12VDC
TV System NTSC
Video Input/Output Composite Video Single (1vp-p 750OHM)
Resolution 800(H) x 480(V)
LCD Brightness 1800cd/m2
Operating Temperature -5
o
F to +149
o
F (-15
o
C to 65
o
C)
Storage Temperature 5
o
F to 158
o
F (-20
o
C to 70
o
C)
DISCLAIMER
The use of Rosco’s Vehicle CCTV system should not in any way be used as a substitute for careful and cautious
driving. Always obey traffic laws and motor safety regulations must always be adhered to. Specifications subject to
change without any notice.
NOTE: On-screen menu commands should only be selected when monitor is in
steady-on mode. Never change settings while operating vehicle.
Press the MENU button once to set desired brightness.
Press +/- to increase/reduce the brightness.
Wait 3 seconds to exit setup mode.
Press the MENU button twice to set desired contrast.
Press +/- to increase/reduce the contrast.
Wait 3 seconds to exit setup mode.
Press the MENU button three times to set desired color.
Press +/- to increase/reduce the color.
Wait 3 seconds to exit setup mode.
Continue to press the MENU button to change desired settings.
Tint: Press +/- to increase/reduce the tint
Language: Press +/- to select English/ French/ Spanish.
Reset: Press +/- to restore factory defaults.
CAM1: Press +/- to select Normal/Mirror mode.
CAM2: Press +/- to select Normal/Mirror mode.
Vertical: Press +/- to flip image vertically.
Dimming: Press +/- to select Auto/ Day/ Night.
Scale: Press +/- to select On/Off for backup grid to appear when in triggered mode.
Scale Adjustment: Press - to change selected line on backup grid.
Press + to adjust position of line on backup grid.
Wait 3 seconds to exit setup mode.
MENU CONFIGURATION
