Rosco Miro Cube 4CA, User Manual

Page: 31 / 36

Warning Messages
31
The Braq Cube has warning messages built in that will instruct
you when an action needs to be taken.
On startup, if a DMX signal is not present on the DMX connectors,
and the fixture is set toDMX mode, all of the LEDs will glow dimly.
This feature can be used for troubleshooting your DMX control
lines. Once DMX is detected the fixture will instantaneously
respondrespond to the command it is given.
The Braq Cube is equipped with an internal temperature sensor.
If an overheat condition is experienced all of the red LEDs will glow
dimly and a warning message will be displayed on the rear LCD. If
this occurs unplug the power connector from the unit and
wait three seconds. Plug the fixture in again. If the same condition
occurs again contact the manufacturer.