www.rosco.com
7
2. Make sure the 2.1mm barrel connector from the power supply is plugged into the
LitePad Vector, and then plug the power supply into mains power: 100 – 240 VAC.
a) The rear display will illuminate.
b) Settings will default to those in use when the unit was last powered down.
3. If desired connect the LitePad Vector to a DMX console using the RJ45 ports on the rear
control panel.
a) The presence of a DMX input signal is automatically detected.
b) “DMX On” will show in the upper right corner of the display.
Manual Control
1. Select Output/Dimming level by rotating the left-hand knob until the desired set point
has been achieved.
a) The current set point will be shown in the lower left-hand portion of the LED display.
b) The Output/Dimming level can also be adjusted by depressing the left-hand knob.
Each push of the knob lowers the output by 10% (100% - 90% - 80% - etc.).
c) Pressing both the left-hand and right-hand knobs simultaneously for 1 second places
the fixture into “Boost” mode, increasing the output by 20%.
i) “Bst on” will flash in the bottom center of the LED display.
i) Depressing both knobs simultaneously for 1 second confirms “Boost” mode;
“Bst On” stops flashing.
ii) Rotating the left-hand knob will disable “Boost” mode and allow normal
Output/Dimming adjustment.
2. Select Color Temp (CCT version only) by rotating the right-hand knob until the desired
set point has been achieved.
a) LitePad CCT can be set to color temperatures ranging from 3000K to 6000K.
b) The current set point will be shown in the lower right portion of the LED display.
c) Seven pre-set color temperatures are stored in the CCT control logic. Push the right-
hand knob to index to the desired pre-set color temperature:
3000K / 3200K / 3600K / 4300K / 5000K / 5600K / 6000K
NOTE: The rear LED display will automatically dim after several seconds if no inputs have
been entered. The display will resume full illumination the next time any of the controls are
operated.
