Ropox 40-44010, User Manual

Page: 10 / 41

10
TF 200.01.0047_eng
4. Mounting instructions
4.1 Installation interfaces
Fixed
(40-44010 and 40-44011)
Construction
The wall must be made of a material suited for
screw mounting and approved for damp rooms.
The hatched area is the minimum area for
reinforcement of the wall. Reinforcement from
floor to ceiling is advisable.
Load-tested in Accordance with DS/ISO 17966,
the maximum user weight has been fixed at
400kg (881 lbs).
Max. tensile load of upper screws
150kg/screw (330 lbs)
The washbasin is supplied with a set of 6 screws
and rawlplugs suitable for mounting on a
concrete wall. The fitter should always consider
the material, condition and strength of the wall
and use screws and rawlplugs suitable for the
specific wall type.
Plumbing
The drain is Ø32
(1 ¼”) and ends in an
Ø32x88.5° drain elbow.
The maximum protrusion of drain connection
and elbow from the wall is 90mm
(3 ½”) to
allow for the covers.
The water supply ends in 2 (two) 90° shut-off
valves with ½” outside thread pointing
downward (not included).
The maximum protrusion of the shut-off valves
from the wall is 90mm
(3 ½”) to allow for the
covers.
If a location of the water supply and drain
different from the recommended positioning is
required or if there is a floor drain, the Support
Washbasin will have no covers.
For purchase of adapters for connection to
various standard installations, see ”Connection
Adapters
– Other Washbasins”.
Note
All dimensions are based on a washbasin height of
710mm (28”) above floor level. If a change of this
height is required, the recommended dimensions
must be changed accordingly.
The illustrations show the left-hand model 40-
44010