Roper Whitney 10M14-H, Operation Manual

Page: 22 / 105

3. To adjust the Scale Factor or Calibration (CAL):
The Calibration, “CAL”, has been preset at the factory to obtain optimum
accuracy. However, due to physical variances some adjusting may be
necessary once the machine is set-up for use.
Pressing & Holding the “PGM” push button in for several seconds will
change the display from Position value to "CAL". Release the "PGM" push
button and the current "CAL" value will be displayed. Pressing the "arrow
right" push button will enter Edit mode and each press of the same key will
toggle between each of the digits which will blink when activated.
To change the blinking digit value, press the "down arrow" push button.
Each press will decrease the value by one (9,8,7,6,5,4,3,2,1,0,-) until the
desired value is obtained.
When finished changing all the digits press the “PGM” push button to
accept this new value. Hold "PGM" push button for several seconds to
return to Position display.
Adjust the “CAL” value slightly up if counter position is short of actual
cut length or down if cut length is too short compared to counter position.
Continue adjusting “CAL” value slightly until desired accuracy is achieved.
NOTE:
Value for “CAL” should fall in the range of 0.9600< CAL<1.0400
Always "HOME" backgauge between adjustments.
DRO PROGRAMMING PARAMETERS
NOTE: All parameters for the Veeder-Root have been factory programmed
and should not need changing or adjusting.
Please call factory if changes are necessary.
20