Roper Whitney 10M14-G, Operation Manual

Page: 22 / 85

SIDE EXTENSION SQUARING GAUGES
Part No. 273940042
The side extension squaring gauges are in 4-foot sections that can be
assembled, with multiples, in 8 or 12 foot total gauge lengths. For most
applications the four-foot section will be adequate. The four-foot sections
are packaged in kit form with applicable scales for dimensional extension.
The following kits are as follows:
1. Initial 4-foot, order P/N 273940042
2. Build-up 8-foot, order P/N 273940043
3. Build-up 12-foot, order P/N 273940044
Note that 8-foot length needs first two part numbers, and 12-foot length
needs all the above part numbers.
An optional flip-type stop for the side extension gauges is available.
It can be ordered under P/N 273940046.
The extension gauge can mount to the shear table at either the right or left
side. A leg is supplied to support the end of the gauge. There may be some
manufacturing variations that will require adjustment of the scales, gauge
height and squares. Allowances are provided for these adjustments.
For specific assembly instructions, refer to the instruction sheets enclosed
with the kits.
FRONT EXTENSION ARMS
Part No. 273940006
The front extension arm kit includes two cast arms, T-bolts and nuts, and
a 8-foot gauge bar. The arms are connected to the table with 7/16-14
machine bolts and lock washers (included in the kit), by using the two inner
set of screw holes on the table front face.
20