ROOTS BT4545, Owner'S Manual, Page: 17 / 24

17
RootsScrub BT Series
Ÿ
For reasons of safety during cleaning and/or
maintenance work in or on the tank, the tank lid -
when lifted - must be secured so as to prevent
accidental closing or tilting down.
Ÿ
The machine may be taken into operation only if all
guarding devices are fitted and in protective position.
As far as possible, cleaning should not be done by
hand, but using appropriate tools or equipment.
Ÿ
Maintenance and repair work may be carried out
only by means of suitable tools and by the people
trained in the factory - for reasons of safety, only
genuine Roots spare parts may be used.
Electrical System
The electrical equipment of this machine uses a mains
voltage of 24 DC. Easy access to brush motor and
vacuum motor is possible after the upper part of the unit
has been titled to upside.
The suction turbine has been provided with a fuse
having a rating of 25A. It must be replaced by a fuse of
same rating.
The brush motor is protected by a fuse having a rating of
35A. When brush motor trips identify the cause and
correct it before trying to run the machine.
The fuses can be changed by removing the rear panel
assembly.
MAINTENANCE
- If there should be repeated cases of failure,
look for the reason.
- Any work at the electrical system has to be
carried out by specialized electricians only.
Maintenance Work
Compliance with our recommendations concerning
maintenance work will give you the certitude always
having a machine at your disposal, which is ready to
work and in good operating condition.
Daily
Every
50
Every
100
Every
200
Check connection -
extension cables and plugs
for good condition; discard
Defective cables immediately
Empty and clean the dirty
water tank
Check the sealing strips of
squeegee for good condition
Check the squeegee for
possibly collected foreign
matter and clean it, if
required
Check the float for proper
operation
Check the suction hose
between squeegee and
Dirty water tank
Check the caps of both
Fresh and dirty water drain
hose; check them for
smooth operation
Check the squeegee
sealing strips for wear;
renew them if required
Check the brush for tight fit
and wear; renew them if
required
Check the tank lid seal;
renew if it is required
Check the fresh water
infeed to the brush
Remove carbon dust from
the suction motor, check the
carbon brush for smooth
operation and wear; renew
as required
Service Hours
Maintenance Schedule
Ÿ
Please contact your local Roots Multiclean Ltd.
distributor; the people there will be glad to perform
that work for you. There well trained personnel and
genuine Roots spare parts are at your disposal.
Ÿ
Well trained personnel and genuine Roots spare
parts are at your disposal.
Ÿ
In case of any inquiries or orders for spare parts,
please always quote the machine's serial number
mentioned on the nameplate.
Ÿ
The name plate is fixed in the rear side of the
machine.
Ÿ
When cleaning or servicing the machine, and when
replacing any parts, shut off the machine and on
principle disconnect the power plug from the power
supply.