Step 4
1.
Clip in side
A
(the motor side) of the Blind to side
A
of the reveal. This
will require some force to clip it in the Blind securely to the frame. Start
at one end moving across to the opposing end.
Clip in the Blind as per the diagram - a loud ‘clicking noise’ will be heard
when pushed into the top of the bracket securely.
2.
Move to the opposite side of the lantern (side
B
) and prepare to fit the static side as per below.
This side requires
moderate force
to clip in the bracket securely. It will seem short on the length (80mm) but this is normal.
Start in the middle and work your way outwards making sure each time it clips into the bracket securely.
3.
The Blind will now be under the correct tension. Ensure the power is off and
get a qualified electrician
to connect
the power to the Blind. Once the power is active
the Blind will jog once
and is ready to be operated
N.B. to
immediately
change the direction of the blind i.e. opening to closing, 'STOP' must be pressed,
after approximately 5 minutes, this is no longer necessary.
Fitting Guide (V.1) |
3 of 6
