USER MANUAL
5
used never attempt to use an incomplete or malfunctioning tool.
10. Keep the arms flexed when the tool is fired (do not straighten the
arms). Stop working with the tool if you feel unwell.
11. always hold the tool perpendicular to the working surface & material
in which the fastener is to be driven.
12. Always use genuine fasteners, cartridges & spare parts.
13. Never attempt to pry a cartridge from magazine strip or tool.
14. If a cartridge misfire or fails to ignite, proceed as follows:
- Keep the tool against the working surface for 30 seconds.
- If the cartridge still fails to fire, withdraw the tool from the working
surface, taking care that it is not pointed towards yourself or any
bystanders.
- Cycle the tool so that the magazine strip is transported to the next
cartridge. Use up the remaining cartridges on the strip. Remove the
used cartridge strip and dispose of it in such a way that it can be neither
reused nor misused.
15. Never attempt to drive a fastener in an existing hole.
16. Always keep the tool & cartridges in a closed container in a safe
place when not in use.
17. Do not make fastening in an explosive or flammable atmosphere.
18. Application recommendation must always be observed.
19. Before using the tool, make sure that no one is standing behind or
below the point where fasteners are to be driven.
20. Don’t disassemble the tool while it is hot.
21. Never exceed 500 times fastening per hour. The tool may otherwise
overheat.
GENERAL NOTES
22. Never attempt to re-drive the same fastener.
23. The applicable national regulations must always be observed,
particularly those relating to accident prevention.
24. This safety device prevents the loaded tool from being fired unless
