RonI, INC
8001 Tower Point Drive
Charlotte, NC 28227
U.S.A.
Toll Free (866) 543-8635
Ph.: (704) 847-2464
Fax: (704) 847-6739
Email:
Web Site: http://www.liftoflex.com
Rev July 2016
12
8.6 Extra lifting height
If applicable, undo the two screws holding the end-effector and then adjust the height 100 mm up which will mean
that you will lose 100 mm on the bottom stroke but gaining the extra lifting height.
Attention! Note that end-effectors do not always completely reach the floor.
9 Maintenance
In order to have a long lasting product please take note of the following.
Every day
1.
Wipe the lifter down with a wet cloth using a non-aggressive cleanser. Do not use any high pressure cleaning
equipment. This will damage the product.
2.
The lifting device shall be charged every night, over weekend, holidays and longer periods when not in use or the
batteries will go dead.
It is not possible to overload them.
Every month or when necessary.
1
Wheels: Check the wheels to make sure they are in good working order.
2
Central braking system: Check all 3 position. Neutral, Directional and Lock.
3
Make sure the handle stays in place by tightening the bolts by hand.
Every year
1.
Electronic connections: Check all the connections and take care of any damages.
2.
Nuts and bolts: Make sure everything is tight.
3.
Mast: Remove mast from frame, see 5.2 but in opposite order. Undo the four bolts on the upper end lid and pull out
the entire screw unit. Undo the end pieces from the holder and check the bearing, add lubricant as necessary.
Mount it back into place. Dry the screw and check the nut and coupling to make sure it is not too worn and
wobbles. Lubricate the screw with lubricant intended for ball bearings. Should the brushes be dirty and need
cleaning, simply pull them out. Clean the inside of the profile and reassemble all components. Place the mast back
in place see under 5.2 Mounting, and check the load platform and the coupling of the slide.
4
Signs: Make sure all signs are in place and readable.
