RONDELL RDE-1050, Manual Instruction

Page: 4 / 24

4
ENGLISH
THERMOPOT RDE-1050
An electric thermopot is intended for boiling water and maintain-
ing the required temperature of water.
DESCRIPTION
1. Minimal water level mark «MIN»
2. Water level scale
3. Water dispense on button
4. Spout for pouring water
5. Control panel
6. Lid opening button
7. Steam release openings
8. Removable upper lid
9. Lid lock
10. Carrying handle
11. Body
12. Power cord connector
13. Base
14. Sealing gasket
15. Maximal water level mark
16. Power cord
Control panel
17. Water boiling mode indicator «BOILING»
18. Keep warm mode indicator
19. Indicator «TEMPERATURE»
20. ECO mode indicator
21. Water type indicators «Tap water», «Drinking water»
22. «ECO mode» button
23. Type selection button
24. «UNLOCK» button
25. Water supply button «DISPENSE»
26. Temperature selection button «Т°С selection»
27. «START/CANCEL» button
ATTENTION!
For additional protection it is reasonable to install a residual cur-
rent device (RCD) with nominal operation current not exceeding
30 mA, to install RCD, contact a specialist.
SAFETY MEASURES
•
Before using the electric thermopot, read this instruction man-
ual carefully.
•
Make sure that the operating voltage of the unit corresponds
to the voltage of your mains.
•
The power cord is equipped with a “euro plug”; plug it into the
socket with reliable grounding contact.
•
To avoid fire, do not use adapters for plugging the unit in.
•
Do not connect or disconnect the power cord with wet hands,
this may cause electric shock or injuries.
•
When unplugging the unit, always pull the plug but not the
cord.
•
Never leave the operating unit unattended.
•
Do not switch the thermopot on if it is empty.
•
Do not drop or tilt the unit.
•
Use the thermopot only for water boiling; it is prohibited to heat
or boil other liquids in it.
•
Ensure that water level in the thermopot is not below the «MIN»
mark and not above the «MAX» mark.
•
Do not fill the thermopot with water directly from the faucet; to
fill the thermopot use a suitable bowl.
•
Place the thermopot on a flat dry and stable surface; do not
place the thermopot on the edge of the table.
•
Do not place the thermopot next to the walls or close to the
kitchen furniture.
•
Place the thermopot keeping at least 20 cm gap between the
thermopot body and the wall and at least 30 cm gap above
the thermopot.
•
Do not use the unit near heat sources or open fire.
•
Do not let the power cord hang from the edge of the table and
make sure it does not touch hot or sharp edges of furniture.
•
Do not open the lid and do not pour water out during boiling.
•
Do not rotate the unit during water pouring.
•
Do not apply excessive effort when closing the lid. When using
the thermopot, make sure that the lid is closed tightly.
•
Keep your hands away and do not bend over the steam release
openings, it may cause burns. Do not block the steam release
opening with any objects.
•
Do not touch hot surfaces of the thermopot.
•
Be careful while carrying the thermopot filled with boiling
water.
•
Do not carry the thermopot holding it by the lid opening button.
•
Be careful when pouring out hot water.
•
Remove the lid before draining the remaining hot water from
the thermopot flask.
•
To avoid risk of electric shock, do not immerse the thermo-
pot, the power cord and the power plug of the unit into water
or other liquids.
•
Unplug the unit, if you are not using it or before cleaning.
•
Do not wash the thermopot in a dishwashing machine.
•
Before taking the unit away for long storage or before cleaning,
unplug it, pour out water and let the unit cool down and dry.
•
For children’s safety reasons do not leave polyethylene bags
used as packaging unattended.
Attention! Do not allow children to play with polyethylene bags or
packaging film. Danger of suffocation!