7
[1] thru [16]
These represent the 16 steps of the sequencer. Press one of the 16 buttons to toggle the step on (lit) or off
(unlit). Lit steps will sound during sequence playback, while unlit steps will not.
[1] thru [16] + C1 (or a note on the keyboard)
Assigns the note to the selected step. Hold down the step button and press a note on the keyboard, or use the
C1 ribbon controller to select a note.
Step Next Step Button (eg. [1] + [2])
Enters a tie between the two step buttons.
[1] thru [16] + C2
Adjusts the gate time of the selected step/note. This is the length of the note, where UP on the C2 ribbon
controller is longer, and DOWN is shorter.
CHORUS 2 + C2
Adjusts the gate time of all steps in the sequence. This is the length of all notes in the sequence, where UP on
the C2 ribbon controller is longer, and DOWN is shorter.
CHORUS 2 + [1] thru [16]
Selects one of the stored sequencer patterns.
CHORUS 2 + [1] thru [16] (long press)
Saves and assigns the current sequencer pattern to the button selected.
[1] [1] thru [16]
Assigns the number of steps in the sequence (min 1, max 16).
[2] [4] thru [12]
Sets the shuffle (default is 8). This plays the notes “out-of-time” or a little offbeat. The higher the number, the
more pronounced the shuffle is.
[3] [1] thru [4]
Sets the scale (default is 2).
[15] [1] thru [7]
Sets the step order, much like an arpeggiator. Choices are:
1
Normal (default)
2
Even/Odd reverse
3
Odd Only
4
Even Only
5
Odd Only
Even Only
6
Even Only
Odd Only
7
Random
[16] [1] thru [2]
Sets Off Step mode as follows:
1
Rest (Default)
2
Skip