Rev 03/2022
V1.0 - Page
4
of
11
Subject to modifications!
romutec Steuer.-und Regelsysteme GmbH Jochsberger Straße 39 D-91592 Buch am Wald
Subject to technical changes
2 General information
2.1 Notes on the operating manual
To take full advantage of your RCG32-devices, you should read all the chapters of this manual
to get information about the features of the equipment and to learn how to safely use the
system.
2.2 Safety information
Before you put your devices into operation, you should read the following carefully. This also applies if
any questions should arise at a later time.
Intended use:
The devices are to be used exclusively for the terms and features specified in this documentation.
With improper use, the manufacturer assumes no product liability and warranty claims.
•
Follow all warnings and notes marked on the device or listed in the technical documentation.
•
Operate the devices only when properly mounted on a DIN rail or in an appropriate mounting
frame
•
The modules should not be installed in the immediate vicinity of frequency converters.
•
Frequency converters must be provided with all safety measures in order to comply with the
required regulations and guidelines (e.g. line filter, etc.)
•
Do not use the product near water or other liquids which can damage the electronic
components.
•
The supply voltage must correspond to the information in the technical data.
•
The terminals of the device should only be wired by authorized and trained personnel.
•
Do not perform wiring work whenever the device is powered. There is a risk of electrical
shock.
•
Connecting and disconnecting the terminals or connectors under voltage should be avoided.
The devices might be destroyed.
•
Make sure that no objects, e.g. screws or other fastening material, gets into the device.
•
Avoid installation in areas with extreme temperature fluctuations. The temperature ranges for
storage and operation which are given in the datasheet must be maintained to ensure trouble-
free operation.
•
Do not install in areas with requirements of explosion-protection (ANEX or any other areas)
•
Use only network cables with insulation an minimum CAT5e-Declatration
However, should problems occur, do not try to repair the device yourself. Do not open or disassemble
the device. Doing so, parts inside the device might be damaged on contact. Basically, if you have any
problems please contact the manufacturer.
