8
Cutting depth adjustment
The cutting depth can be adjusted from 0
to 40 mm.
Loosen the toggle screw and with the help
of the depth stop, set the required cutting
depth to match the thickness of the work
piece to be cut.
Then tighten the screws again.
After completing the work, set the depth
stop to zero to prevent the blade guard
from being accidentally pushed back.
Risk of injury!
Overload Protection
In order to protect the user, the motor and the tool, the
Renovation Saw
–
Start
is equipped with an electronic and thermal overload protection.
Electronic:
In case of overload caused by a grinding pressure
which is too high, the electronics react by decreasing the
speed of the machine. You can continue working when the
grinding pressure has been reduced.
Thermal:
By means of a thermal sensor, in case of continuous
overload, the motor is protected against destruction. In
fact, the machine switches off automatically and only can
be switched on again after a certain cooling period (about 2
minutes). Press the on/off switch. The cooling period
depends on the heating of motor winding and ambient
temperature.