10.
Detailed Description
Transform a corner of a room into an interactive Snoezelen® Multi-Sensory Environment –
ideal for those with little space. This kit includes some of the most popular elements of a
Snoezelen® Multi-Sensory Environment and has been designed to be installed easily
(without the need of professional help). This comprehensive and affordable Snoezelen®
Sensory Corner Kit includes:
* 2 Curved Mirrors 1.65m x 80cm
* Maxi 1.5 Bubble Tube
* Fibre Optics 2m x 200 strands
* Light Source
* Cream Cushioned Platform 80 x 80cm
* 8 Colour Wirefree Switch
* Bubble Tube Collar (15cm)
11.
Safety
Always supervise the use of all of these products
12.
Technical Specification
Size:
cushioned platform 80 x 80cm
fibre optics 2m long
bubble tube 157cm high overall
mirrors 165 high x 80cm wide
This kit requires two electrical sockets – to plug in the light source and the bubble tube.
13.
Installation
Choose an appropriate location. You will require two nearby electrical wall sockets.
1.
Attach the mirrors to the walls of your corner:
-
Measure your wall first, allowing for the bottom of the mirror to be
approximately 5cm below the top of the cushioned platform. Usually a mirror
this size would be sat on top of the skirting board.
-
First attach the board to the wall, then the mirror to the board. Fit one board with
mirror to the wall at a time.
-
Unless the wall is already boarded, the board supplied should be fixed to the wall and
the screws countersunk. Place screws/cups every 30cm, approximately 1cm in from
edge.
-
Attach the mirror panels to the board using a good quality, proprietary brand
contact adhesive or double sided tape e.g. Evo-Stick. The edges should be securely
glued/taped in. It is your responsibility to check that the adhesive you use is
adequate to hold the mirror, and that a sufficient amount is used at the edges and
at regular intervals across the whole of the back of the mirror. Apply plenty of tape
or glue. If using glue, spread the glue over the back before attaching the board.
Seek professional advice if in any doubt. You may wish to screw the mirror to the
board – if so, please choose appropriate tools and fixings. Whichever fixing method
is chosen, use enough tape/glue/screws to make sure the mirror does not warp.
-
Remove the protective film.
