Please follow the separate instructions supplied for the Acrylic Mirrors.
2.
Pass the fibre optic harness through the mouse hole and attach the harness to the
light source.
-
Turn the cushioned platform over and attach the light source to the wood inside
the platform.
-
Slide the boss of your fibre optics into the circular hole in the front face of the light
source, and tighten the screw on the top of the unit to secure the fibre optics.
-
Connect the power lead until this is a tight fit.
Please follow the separate instructions supplied for the Light Source.
3.
Put the bubble tube chassis in the corner
-
Put the base of the bubble tube (without the white cover) into the corner. The
hole in the top of the cushioned platform will need to be over this base so line
these up accordingly.
-
The cushioned platform should be pushed into the corner against the mirrors.
The bottom of the mirrors should be below the top of the cushioned platform.
4.
Place the cushioned platform in position, over the bubble tube chassis.
-
Lift off the top cushion off the cushioned platform.
-
Lift open the trap door of the cushioned platform (usually in two halves).
5.
Assemble the bubble tube through the trap door in the cushioned platform.
-
Remove the plastic base cover from the base unit (keep this on one side should
you wish to use the bubble tube outside the cushioned platform).
-
Fit the bubble tube column to the base using the large screws provided. Note
the location of the valves before screwing in place – orientate the column so the
pipes are near to their corresponding valve.
-
Attach the cloudy plastic pipe to the blue valve on the Bubble Tube Column and
the brown plastic pipe, which is already attached to the pump, to the metal
valve at the bottom of the Bubble Tube Column.
Please follow the separate instructions supplied for the Maxi Bubble Tube.
6.
Fill the bubble tube.
-
Check all pipes are properly and firmly connected.
-
Check the lights are working before filling with water. Place the Bubble Tube in
its final position, on a stable, level surface.
-
Fill with clean water carefully until the required level is achieved (approximately
5cm from the top of the tube). Put the bubble tube cap on top of the bubble tube
once the cushioned platform is in place. Remove the protective plastic film from
the column
.
Please follow the separate instructions supplied for the Maxi Bubble Tube.
7.
Plug in the light source and bubble tube and switch everything on.
8.
Put the trap door back on top of the cushioned platform, followed by the top cushion
9.
Align the components
-
Straighten everything up so that the cushioned platform is pushed into the corner
