LOWEST
POSITION
MIDDLE POSITION
HIGHEST
POSITION
LOWEST
POSITION
MIDDLE POSITION
HIGHEST
POSITION
STEP 4
Assemble the mattress support using 4 bigger
round head bolts
(2)
, 4
"butterfly" type nuts
(6)
, 4
smaller lock washers
(5)
and a Phillips screwdriver
(not supplied). The lock washer must be attached
to the bolt after the bolt passed through the frame
and the metallic bracket of the mattress support
and before attaching the nut.
There are three positions for the mattress support
(from the highest one for a newborn to the lowest
one for a child that is maximum 35" tall - see
caution note). You must adjust the height of the
mattress support depending of your child height by
inserting all the four bolts in the same position
(see
FIGURE 4
).
Do not completely tighten the bolts at
this step, you will be asked to do this later.
NOTE:
THE STYLE OF YOUR CRIB OR
OF YOUR MATTRESS SUPPORT MAY
VARY FROM WHAT IS PICTURED IN
T H E I N S T R U C T I O N S H E E T
FIGURE 4
2
6
2
6
2
6
2
6
2
6
5
5
5
5
9
A D J U S T I N G T H E H E I G H T O F Y O U R M A T T R E S S S U P P O R T
To adjust the vertical position of your mattress support you must remove all four bolts & nuts
(2+5+6),
loosen
all four bolts
(3+5)
, lower the frame and insert the bolts
(2)
back into the corresponding holes, according to the
desired height (see
FIGURE 4
). Then, you must attach the lock washers
(5)
and the nuts
(6)
as described in
STEP 4
and completely tighten all the bolts.
Your crib is designed in such a manner that, when the mattress support is adjusted to its lowest
position, the mattress support frame must be placed directly over the stabilizing bars. Before tighten
the bolts, you must slightly press the mattress support frame to make sure this position is achieved.
WARNING:
TO KEEP YOUR BABY SECURE AND SAFE,
AND TO AVOID POTENTIAL INJURY OR
DEATH,
IT'S VERY IMPORTANT TO COMPLETELY TIGHTEN ALL 8 BOLTS (2+5+6) &
(3+5) AFTER YOU HAVE
ADJUSTED THE HEIGHT OF YOUR MATTRESS
SUPPORT
.
Summary of Contents for 3510s
Page 2: ......
