77-014 - Yasui Rotating Burnout Furnace 37+
5
1.
SAFETY INFORMATION
WARNING
1. Since this machine produces very high temperature (more than 700 degrees Celsius), always
pay attention not to suffer burns.
Do not allow unskilled or untrained person to operate this machine.
2. This machine is electric furnace designed for lost-wax casting. However, depending upon
material, it may be possible to use the machine for burning plastics (such as material for Rapid
Prototyping). If you need to use plastics, examine properties of the plastics beforehand
thoroughly and carefully and check for safety because various plastic materials are distributed on
the market.
3. Do not use or stock any inflammable gas, inflammable volatile liquid, or organic solvent near
the machine or in the room where the machine is installed.
4. When incomplete combustion gas of wax is generated, do not open the door. If you open the
door at this time, inside of the furnace may be combusted and flame may spread toward front
through the gap between the door and the furnace body.
5. Before connecting tubes for auto door, be sure to set the insert pin to the handle of door to
release the door lock. Removal of the insert pin after the auto door has been installed may cause
unexpected and very rapid opening of the door, which may cause injury.
6. Never stand in front of the door, when air is initially supplied to the auto door or when air is
once shut off and then supplied again to the auto door to replace air supply source, as the door
may unexpectedly and rapidly open or close, which may cause injury.
7. During or just after burnout, surrounding
parts of the furnace opening especially
the metal plates for guard of the adiabatic
material are heated to very high temperature,
So take utmost care not to burn your
hands etc.
