Step 6 - Fitting the Seals
1. At the bottom of panel assembly, place a bead of silicon between the plass and the bottom rails. Fit the
blanking end and carefully remove any excess silicon.
2. At door end, place a bead of silicon around the bottom rails. Fit the end cap and carefully remove any
excess silicon.
3.
Cut the flipper seal at the edges of the rebate to create three sections of seals. Fit the seals onto the
hinged panel glass edge on the hinge side with the flipper of the seal on the inside of the enclosure. Trim
the top and bottom seals to length if required. (centre seal should be to length)
•
IMPORTANT: Please ensure that the flipper part of the seal is on the inside of the enclosure.
4. The bottom seal requires a rebate at one end only (hinge side). Fit the bottom seal so that the rebated
end is level with the glass at the hinge side of the moving panel and cut it to length so that it butts up to
plain end of the glass. Push fully onto the glass.
•
IMPORTANT: The seal is rebated at both ends, remove the rebate that is not required. You
MUST ensure that the deflector on the bottom seal is facing inward towards the shower.
①
④
①
Rebate
↓
Flipper
↓
②
② ③
Cut Any
Excess
③
Cut
Cut
Cut Any
Excess
Rebate
Rebate
