Step 5 – Installation of Door onto Tray and Fix 2nd Wall Profile
1. Prior to fixing to second wall profile to wall, apply a bead of silicon the width of the wall profile, where the 2nd wall profile will
meet the tray and tiled wall at the bottom
2. Place your door fully into the wall profile that you have already fixed to the wall, push the door as far into the wall as possible.
Important: Ensure that that the hinge/fixed of the door is pushed into the wall profile that is already fitted to the wall.
3. Insert the loose wall profile into the other end of the door and push the wall profile as far as possible into the door.
4. The 2nd wall profile can now to be pushed back to the wall and secured through the lip using the 40mm screws supplied into
the wall plugs that were fitted during Step 3.
Important: The wall profiles must be completely vertical (the bubble should be in the centre of the two lines on the spirit
level). The sealant must be applied in steps 2 +5; failure to follow out this procedure may result in serious water
damage and is not covered under the terms of the guarantee.
➀
➁
➂
➃
ET Sliding Door:CSP 4/5/10 11:33 Page 6
