To set up a new automated cycle press and the clock will start flashing.t
Press
△
or
▽
to select EDIT.
1: Press “MON” will start flashing, (you can select a specific day with
△
or ) but during first set up select
MON, (Monday) and press again to continue.
2: WAKE will now be flashing, (you can select specific period with
△
or
▽)
but again during initial setup
select “WAKE”
and press
to continue.
3: The Time Hours will be flashing. Use
△
and
▽
to set the time you would like the heating to come on in the
morning / when you wake and press to confirm and set the minutes again using the
△
and
▽
keys. Once
done press to continue. Note: The time you are setting is the time you want the heating to change
temperature for the day and period you have selected in steps 1 & 2 above. In step 4 next you will set the
temperature you want the thermostat to change to for the duration of this period.
4: Temperature will now be flashing. Use
△
and
▽
to set your new temperature you would like at the time
you have just set in step 3, once done press to continue - (LEAVE should now be flashing).
You have just completed the “WAKE” period for “MON”. Now repeat the above steps for each period, (WAKE -
LEAVE - RETURN - SLEEP) for each day of the week using to select and move on,
△
&
▽
to make changes
and to go back if needed.
To set HOLD mode press and the clock will start flashing.
Press
△
or
▽
to select HOLD.
Press and hold hours will start flashing.
Note: In hold mode,’HOLD’ will show on display.
Set the hold time to 00:00 to cancel hold mode.
This thermostat can be programmed to automate your heating cycle. The programming is based upon 4
Periods per day - 7 day cycle, WAKE - LEAVE - RETURN - SLEEP / Monday - Sunday. A time and temperature
will need to be set for each period of each day. This will then allow the thermostat to change the
temperature up and down as per your set temperature for each period to suit your lifestyle.
Note: There is no On or Off settings in this mode but simply different temperatures. If you set a tempera
-
ture below ambient room temperature the thermostat will keep the heating off. If you set a temperature
above Ambient room temperature the thermostat will turn the heating on until the set temperature is
achieved. The default automated setting times and temperatures are shown in the table on page 10.
Press
△
or
▽
to set hour.
Press and hold minutes will start flashing.
Press
△
or
▽
to set minute.
Press and hold temperature will start flashing.
Press
△
or
▽
to set hold temperature.
Press to confirm and return to the home screen.
07
08
Automated Heating Cycle Mode.
▽
