Roma Heating CT1000, User Manual

Page: 9 / 16

This setting alows the user to select
between air, floor or a combination
of air & floor sensors.
I = Internal Air Sensor Temp.
E = External Floor Probe Temp.
I&E = The thermostat will only regualte air temp but will show all 3
temperatures. If however the floor temp exceeds the high or low
temperature protection settings the heating will turn off or on
until the floor temperature no longer exceed these settings. During
this time a Yellow warning triangle will appear on screen.
IorE = Only floor temperature will be regulated and shown along with
set temp. If however the air temp drops below the Low Protection
setting then the heating will turn on.
Setting Page 3: EL Units Only.
Backlight Time. This is the time
the screen is fully illuminated before
turning down in brightness.
Backlight Min.is the % of maximum
brightness the screen will show
when not in use. Backlight Max is the % of maximum brightness
the screen will show when in use. Backlight On/Off. Backlight can
be set to full off when screen is not in use. NOTE: A low backlight
or full off is best for bedrooms.
Settings Page 2, NTC Select.
Settings Page 4, Backlighting.