Page 48
RS-500/600 Series Doors
Part No 4801-5154 Rev 01-2017
Diagram 32A
Diagram 32B
Diagram 32C
33
Emergency Egress (Optional Feature)
The Emergency Egress feature provides a simple and convenient means of exiting a Roll Seal RS-500 Door from the
inside of the structure should the door motor become inoperative due to a power failure or other conditions.
33.1
Installation
Install the Egress Tool Retainer (1040-8400) to the left or right side outside of door jamb. For a wood framed
door jambs use #10 x1
screw (1004-1386). For a metal framed door jamb use #8x1/2 Tek screw (1004-
2492).
See Diagram 32A.
The Egress Tool Tether (1040-8401) provides a means of attaching the egress hook to a location on the wall
to prevent loss of the egress hook. This tether provides up to eight feet of cable. It can be mounted anywhere
necessary to allow reach, hook, and pull of the Egress D-ring. The tether can be used on doors up to 10’ x 10’.
Attach the Tether with four (4) ¼” phillips screws (1004-2068).
33.2
Exiting (Opening) The Door
1.
Remove Emergency Egress Tool from the retainers on the
side of the door.
2.
Connect the hook end of the tool to the
D-Ring on the top of the door frame.
See Diagram 35B and Diagram 35C
.
3.
Pull down on the Egress Strap. The Door will raise
approximately half way up. The door will open enough for
a person to exit the structure.
See Diagram 33D
.
Install the Emergency
Egress Tool Retainer
on the door jam
Cam
Buckle
Egress
Strap
D-ring
Egress
Tool
Egress Tether
Egress
Retainer
Summary of Contents for RS-500 Series
