RollSeal RS-500 Series, Installation Manual

Page: 27 / 68

Part No 4801-5154 Rev 01-2017 RS-500/600 Series Doors Page 27
Chain Hoist Disconnect Mechanism
Manual Mode Return to Electric Mode Storage
Pull chain on either side Wiggle chain until Follow the 3 steps shown below
to operate door. it moves freely. to attach the chain (when not in
use) to the chain keeper.
16 Manaras Motor Operation
Complete installation and operating instructions are provided with the Manaras Operator at the time of delivery.
Refer to these instructions for the proper installation and alignment of the Manaras operator.
After the door has been secured to its frame (see
Section 13.8
), the Manaras motor has been mounted with chain,
spreader bar and associated hardware (see
Section 14
), the door will be ready to operate after completing the
following steps.
Warning!
NEVER RELEASE CHAIN! If Chain Is Released, Door Will Drop With Rapid Motion.
Injury May Occur If Chain Is Released!
Do not remove the cable tie securing the chain to the chain guide until after the
chain bracket is completely installed and the chain is secure. Remove and discard
the cable tie securing the chain to the chain guide prior to manual operation.
Warning!
Do not remove the cable ties from around the door head unit until the door is installed to the
door frame and the Manaras Operator is properly installed to the door drive shaft. Without
proper support, the door will drop with rapid motion and injury may occur.
Before using the Manaras Operator’s UP/DOWN manual chain or switch controls,
ensure the shipment cable ties and drive shaft safety brackets are removed
from around the door head unit.
Warning!
To Avoid The Danger Of Possible Damage To The Door And Operator, Travelling Cams
Must Be Adjusted To Their Approximate Positions Before Manually Operating The
Door Or Before Applying Power To The Operator.
!
!
!