16
Rollerdor RD77 Installation Guide, Edition 2022/01
fig.8.4
5
Move the plastic wand in to the other limit with the arrow pointing
towards you and turn 10 times in the negative direction.
6
Press and hold the down button so the curtain closes, it should stop
before it touches the floor if this is not the case take the curtain back up
300mm off the floor and turn again 15 times in the negative direction,
take the curtain back down and repeat until the curtain does stop before
it reaches the floor.
7
For Somfy Rollixo ONLY:
Turn the limit towards the positive (+) direction.
After each couple of turns, open the curtain slightly and then close it each
time closing a bit further.
For all other control systems:
Whilst holding the closed button on the
handset turn the wand in the positive direction and the curtain will start
to judder down.
8
Keep repeating until the curtain is fully compressed and pressure is
applied from the top via the locking strap. The ideal finishing position of
the curtain is to have the top of the guide runner exactly in the middle of
the very top slat
(fig.8.4)
but no more than 1 full slat above the top of the
guide runner
(fig.8.3)
if there is more than this you will need to remove
the extra slats.
9
Close the curtain down to make sure it doesn't catch anywhere and the
front case is not bowed in so as to rub on the curtain during operation,
then seal down the sides and along the top case as needed (silicone
sealant is recommended).