8
4. Loading Negatives
Hold up the negative toward the light. As you look through the negative you should be able to read
the small negative numbers normally (not a mirror image).
Now turn the negative so the image is upside down while looking at the same side.
Open the negative holder at the marked spot on the top.
With the negative holder open, place the negative into holder so the notches line up with the
notches on the holder.
Note:
Handle negatives with care. Any dust, scratches or fingerprints will show up on your saved
images. If possible use cotton gloves when handling negatives. It is recommended to use
compressed air to remove any dust on the negatives. This is not included with the film &
photo scanner but can be purchased from an office supply or electronics retailer.
Close the negative holder and press the edges so that it locks in place
Hold it in the position as shown in the film & photo scanner.
Insert the negative holder into the slot on the right side of the film & photo scanner as shown.
Film Holder:
The design of the film holder follows the ISO standard. In some cases the holes on the
film will not match exactly to the alignment of the holder. This is caused by a non-
standard camera. In this case there will be a small black line on the edge of the frame
that can easily be cropped out using photo editing software.
ISO--
International Organization for Standardization