Operation manual / Spare parts list
Single disc machines
12
6.5
Leading the machine
By slight push of the handle down the machine turns to the left.
By slight pull of the handle up the machine turns to the right.
Caution! Move the handle very carefully. By release and holding of the handle in the same position, the
machine turns on the same place.
Attention! When crossing and damaging the electrical cable:
DANGER due to electric shock!
6.6
Speed regulation (RO-3000V only)
With the Single disc machine RO-3000V you can switch the speed between 120 rpm and
280 rpm.
With the push-button at the back side of the handle you can switch the speed to 308 rpm.
The conversion occurs with the rotary counter on the front of the handle.
6.7
After the operation
1. Dismount and clean the disc resp. the special disc.
Operation steps:
1. Switch off the machine and disconnect the connection cable from the mains.
2. Tilt back the machine to the floor with vertically put handle.
3. Unlock the flange of the disc from the machine (Bayonet connector). Put the machine in
horizontal position again.
2. Roll up the connection cable
Roll up the cable around the lower cable holder and the handle grip.
Attention! Check the cable while rolling up and remove impurities like dust and sanding remainders.
3. Clean the liquid tank
After the use empty the liquid tank to avoid crustification by cleansing liquid.
