Installation
EVSM-V01-R1 Installation and Operation Manual
SecuriCharge Intelligent EV Charging Unit
December 2022
Page
20
of
33
Install the Chargepoint
IMPORTANT:
All electrical work must be performed in accordance with the current
legislation applicable in the geographical region of the installation.
CAUTION: Equipment Damage – Sensitive Equipment
If you will be performing insulation resistance tests on the power supply cables, it is
advised to be done BEFORE connecting the power cable to the chargepoint. The high
voltages applied during the test may damage sensitive components if tested after the
cable is connected.
CAUTION: Equipment Damage
Do NOT use power tools to remove/install panel fixings.
Power tools can damage the fixings, making the panel difficult to remove.
Use hand tools ONLY and do not overtighten fasteners.
IMPORTANT:
If
Load Balancing
is required, install it before completing the standard
installation.
Refer to page 22 Install Load Balancing
shown immediately after these
‘standard’ installation instructions.
Alternatively, if a third-party Load Balancing or Load Management device/system is to
be used, refer to the manufacturer’s instructions
.
1. Remove and retain the fixings that secure the front fascia of the unit to the rear
enclosure.
2. Remove the front fascia and place it to one side.
x
Take care not to damage or disturb electrical cables that pass between the
rear enclosure and front fascia.
x
Make sure the fascia is supported and does not hang by the electrical cables.
3. Carefully cut a suitably sized hole in the rear section of the enclosure to receive the
power supply cable (and the CT and Ethernet cable if required) and an
appropriate cable gland(s).
x
Take care not to damage any internal components when cutting holes.
x
Make sure to remove all debris that could interfere with components inside the
enclosure.
4. Position the unit in the mounting location and use the mounting holes as a guide to
mark
the drilling points.
x
Make sure the enclosure is level before marking the holes.
x
Do NOT drill with the unit in position. Drilling debris may damage electrical
components and will invalidate the warranty.
5. Drill the mounting location at the marked points to suit the fixings that will be used.
CAUTION: Equipment Damage
The Fascia panel is connected to the main assembly by electrical cables. Take care not
to damage, strain, or disconnect the cables. Make sure all connections are secure before
refitting the panel.
