Roland SC-545EX Print&Cut, User Manual

Page: 29 / 135

27
Chapter 1: Getting Started
1-4 Connecting the Cables
Connecting the Power Cord
Use only with a power supply of the same rating as indicated on the unit.
Use with any other power supply may lead to fire or electrocution.
Ground the unit with the ground wire.
Failure to do so may result in risk of electrical shock in the even of a mechanical problem.
Use only with the power cord included with this product.
Use with other than the included power cord may lead to fire or electrocution.
Do not connect the power cord with other electrical loads on a single electrical outlet.
Doing so may generate heat and cause fire.
Rear
Power Connector
Be sure to use an electrical outlet for the power supply. Also, do not connect multiple electrical loads on a single electrical outlet.
Low or unstable voltage may result in inadequate print heater performance. If the temperature of the print heater fails to rise
adequately even when used correctly, check the voltage of the power supply.
Securely connect the power cord, computer I/O cable and so on so that they will not be unplugged and cause failure during
operation. Doing so may lead to faulty operation or breakdown.
Before connecting the cable, make sure the computer’s power and the main power switch of the unit are switched off.
Arrange the power cord and interface connection cable to prevent tripping when moving around the unit.
Power outlet
Power connector
Power cord