Roland SC-545EX Print&Cut, User Manual

Page: 122 / 135

120
Chapter 7: What to Do If...
Meaning
Discard discharged ink.
* This message appears before operations that
will discharge large amounts of ink.
There is a chance of discharged ink overflowing
if operations are carried out while the drain bottle
is full.
Check that the drain bottle is set in position.
Do not use media clamps.
*This message appears when position the print
head at 1 (low).
The size of the data is larger than the printing or
cutting area of the loaded media.
• The size of the data including the crop marks is
larger than the printing or cutting area of the
loaded media.
• The size of the data being output is too small.
A motor error occurred.
The air temperature where installed is lower than
the ambient temperature at which the unit can
operate (approx. 5°C (41°F) or more lower).
Action
Remove the drain bottle from this machine,
discard the collected ink, then reinstall the drain
bottle. Press the [ENTER] key to continue.
Set the drain bottle in place. Press the [ENTER]
key to continue.
Detach media clamps to the media.
Press the [ENTER] key to continue.
To continue performing output without correct-
ing this, press the [ENTER] key. At this time, the
portion extending beyond the printing or cutting
area is not output.
To stop output, stop sending data from the
computer, then press the [SETUP] key. Make the
printing or cutting area wider such as by
replacing the media with large media or changing
the positions of the pinch rollers, then send the
data again.
• To continue performing output without
correcting this, press the [ENTER] key. At this
time, the portion extending beyond the printing
or cutting area and cropmarks are not output.
To stop output, stop sending data from the
computer, then press the [SETUP] key. Make the
printing or cutting area wider such as by
replacing the media with large media or changing
the positions of the pinch rollers, then send the
data again.
• Make the size of the data at least 40 mm
(scanning direction) by 15 mm (feed direction)
(1-5/8 in. by 5/8 in.).
To continue performing output without correct-
ing this, press the [ENTER] key. At this time, the
data output without printing the crop marks.
To stop output, stop sending data from the
computer, then press the [SETUP] key. Change
the size of the data, then send the data again.
Recovery from this problem is impossible. Use
the POWER key to switch the power off and
back on again.
After rectifying the cause of the error (a media
jam or the like), switch on the power.
Do not leave the unit with the print-head carriage
not in standby position.
Recovery from this problem is impossible. Use
the [POWER] key to switch the power off. First
raise the temperature of the area where installed,
then switch on the power.
Messages
EMPTY
DRAIN BOTTLE
INSTALL
DRAIN BOTTLE
DO NOT USE
MEDIA CLAMPS
SHEET TOO SMALL
CONTINUE?
CAN'T PRINT CROP
CONTINUE?
MOTOR ERROR
TURN OFF POWER
TEMPERATURE
IS TOO LOW
7-2 What to Do If an Error Message Appears